Electrical › Heating air conditioning ventilation system › Repair
HVAC总成 · T00617343

 HVAC assemblyHVAC总成

Removal procedure拆卸程序
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面,启用驻车制动,使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
2. Remove the driver's side lower left decorative panel assembly2. 拆卸驾驶侧左下装饰板总成
3. Remove the driver’s side lower cover panel assembly3. 拆卸驾驶侧下护板总成
4. Remove the passenger side lower right decorative panel assembly4. 拆卸副驾驶侧右下装饰板总成
5. Remove the left front extension plate assembly5. 拆卸左前延伸板总成
6. Remove the right front extension plate assembly6. 拆卸右前延伸板总成
7. Remove the switch panel assembly7. 拆卸开关面板总成
8. Remove the sub-instrument panel body assembly8. 拆卸副仪表板本体总成
9. Remove the left A-pillar upper trim panel assembly9. 拆卸左A柱上饰板总成
10. Remove the right A-pillar upper trim panel assembly10. 拆卸右A柱上饰板总成
11. Remove driver airbag11. 拆卸驾驶员安全气囊
12. Remove the steering wheel assembly12. 拆卸方向盘总成
13. Remove the steering column lower guard assembly13. 拆卸转向管柱下护罩总成
14. Remove the steering column upper guard assembly14. 拆卸转向管柱上护罩总成
15. Disassemble the combination switch and clock spring assembly15. 拆卸组合开关与时钟弹簧总成
16. Remove the instrument cluster screen16. 拆卸组合仪表屏
17. Remove the touch control screen17. 拆卸触摸控制屏
18. Remove the DVD mounting bracket18. 拆卸DVD安装支架
19. Remove the speaker mask assembly19. 拆卸扬声器面罩总成
20. Remove the mid-range speaker assembly (in the instrument panel)20. 拆卸中音扬声器总成(仪表板中)
21. Remove the left end cover assembly of the instrument panel21. 拆卸仪表板左侧端盖总成
22. Remove the left end cover of the instrument panel22. 拆卸仪表板左侧端盖盖板
23. Remove the air outlet assembly on the left side of the instrument panel23. 拆卸仪表板左侧出风口总成
24. Remove the left center decorative panel assembly on the driver's side24. 拆卸驾驶侧左中装饰板总成
25. Remove the right end cover assembly of the instrument panel25. 拆卸仪表板右侧端盖总成
26. Remove the right end cover of the instrument panel26. 拆卸仪表板右侧端盖盖板
27. Remove the right center decorative panel assembly on the passenger side27. 拆卸副驾驶侧右中装饰板总成
28. Remove the air outlet assembly on the right side of the instrument panel28. 拆卸仪表板右侧出风口总成
29. Remove the center panel assembly29. 拆卸中央面板总成
30. Remove the instrument panel body assembly30. 拆卸仪表板本体总成
31. Remove the left side cover of the wiper cover31. 拆卸雨刮盖板左侧盖板
32. Remove the right side cover of the wiper blade.32. 拆卸雨刮盖板右侧盖板
33. Remove the left scraper arm33. 拆卸左刮臂
34. Remove the right scraper arm34. 拆卸右刮臂
35. Remove the wiper cover35. 拆卸雨刮盖板
36. Disassembly of the instrument panel crossbeam assembly36. 拆卸仪表板横梁总成
37. Disassemble HVAC assembly37. 拆卸HVAC总成
Graphic
1 Remove the 2 fixing bolts ① and disconnect the air conditioning pipelines A and B from the HVAC assembly.拆卸2颗固定螺栓①,断开空调管路A、B与HVAC总成的连接。
Recommended tools: 10mm socket推荐工具:10mm套筒
2 Remove the fixing bolt ②.拆卸固定螺栓②。
Recommended tools: 10mm socket推荐工具:10mm套筒
Graphic
3 Disconnect the drain pipe A from the HVAC assembly B, remove the fixing bolts ①, and take out the HVAC assembly B.断开排水管A与HVAC总成B的连接,拆卸固定螺栓①,取出HVAC总成B。
Recommended tools: 10mm socket推荐工具:10mm套筒
Installation procedure安装程序
1. Install HVAC assembly1. 安装HVAC总成
Graphic
1 Place and adjust HVAC assembly B to the installation position, install and tighten the fixing bolts ①, and connect drain pipe A to HVAC assembly B.放置并调整HVAC总成B到安装位置,安装固定螺栓①并紧固,连接排水管A到HVAC总成B。
Recommended tools: 10mm socket推荐工具:10mm套筒
Torque requirement: 6-10N·m扭矩要求:6-10N•m
Graphic
2 Install the fixing bolt ② and tighten it.安装固定螺栓②并紧固。
Recommended tools: 10mm socket推荐工具:10mm套筒
Torque requirement: 6-10N·m扭矩要求:6-10N•m
3 Connect the air conditioning pipelines A and B to the HVAC assembly, install 2 fixing bolts ① and tighten them.连接空调管路A、B到HVAC总成,安装2颗固定螺栓①并紧固。
Recommended tools: 10mm socket推荐工具:10mm套筒
Torque requirement: 6-10N·m扭矩要求:6-10N•m
  Caution:注意:
♦  The O-ring of the air conditioning pipeline is a disposable part, please use new parts for each installation.空调管路O型圈为一次性部件,每次安装请使用新件。
2. Install the instrument panel cross member assembly2. 安装仪表板横梁总成
3. Install the wiper cover3. 安装雨刮盖板
4. Install the left side cover of the wiper cover4. 安装雨刮盖板左侧盖板
5. Install the right side cover of the wiper cover5. 安装雨刮盖板右侧盖板
6. Install the left scraper arm6. 安装左刮臂
7. Install the right scraper arm7. 安装右刮臂
8. Install the instrument panel body assembly8. 安装仪表板本体总成
9. Install the center panel assembly9. 安装中央面板总成
10. Install the air outlet assembly on the right side of the instrument panel10. 安装仪表板右侧出风口总成
11. Install the right center decorative panel assembly on the passenger side11. 安装副驾驶侧右中装饰板总成
12. Install the right end cover of the instrument panel12. 安装仪表板右侧端盖盖板
13. Install the right end cover assembly of the instrument panel13. 安装仪表板右侧端盖总成
14. Install the driver's side left middle decorative panel assembly14. 安装驾驶侧左中装饰板总成
15. Install the air outlet assembly on the left side of the instrument panel15. 安装仪表板左侧出风口总成
16. Install the left end cover of the instrument panel16. 安装仪表板左侧端盖盖板
17. Install the left end cover assembly of the instrument panel17. 安装仪表板左侧端盖总成
18. Install the midrange speaker assembly (in the instrument panel)18. 安装中音扬声器总成(仪表板中)
19. Install the speaker mask assembly19. 安装扬声器面罩总成
20. Install the DVD mounting bracket20. 安装DVD安装支架
21. Install the touch control screen21. 安装触摸控制屏
22. Install the instrument cluster screen22. 安装组合仪表屏
23. Install the combination switch and clock spring assembly23. 安装组合开关与时钟弹簧总成
24. Install the steering column upper guard assembly24. 安装转向管柱上护罩总成
25. Install the steering column lower guard assembly25. 安装转向管柱下护罩总成
26. Install the steering wheel assembly26. 安装方向盘总成
27. Install driver airbag27. 安装驾驶员安全气囊
28. Install the right A-pillar upper trim panel assembly28. 安装右A柱上饰板总成
29. Install the left A-pillar upper trim panel assembly29. 安装左A柱上饰板总成
30. Install the sub-instrument panel body assembly30. 安装副仪表板本体总成
31. Install switch panel assembly31. 安装开关面板总成
32. Install right front extension panel assembly32. 安装右前延伸板总成
33. Install left front extension panel assembly33. 安装左前延伸板总成
34. Install the lower right trim panel assembly on the passenger side.34. 安装副驾驶侧右下装饰板总成
35. Install driver's side underbody protection assembly35. 安装驾驶侧下护板总成
36. Install the driver's side lower left trim panel assembly.36. 安装驾驶侧左下装饰板总成
37. Connect the negative terminal of the 12V battery37. 连接蓄电池负极