Switch panel assembly开关面板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the switch panel assembly2. 拆卸开关面板总成

1 Pry out the switch panel assembly.撬出开关面板总成。 Recommended tools: clip remover推荐工具：卡扣起子   Note:提示： ♦  Pay attention to the 6 clip locations in the picture.注意图示6处卡子位置。

2 Disconnect connectors A, B, C, and D, and remove the switch panel assembly.断开接插件A、B、C、D，取下开关面板总成。

3 Remove USB charger A and backup power socket B.拆卸USB充电器A、后备电源插座B。

Installation procedure安装程序

1. Install the switch panel assembly1. 安装开关面板总成

1 Install USB charger A and backup power socket B to the switch panel assembly.安装USB充电器A、后备电源插座B至开关面板总成上。

2 Connect connectors A, B, C, and D.连接接插件A、B、C、D。

3 Place and adjust the switch panel assembly to the installation position, align the 6 clip positions shown in the figure and press firmly to ensure that it is installed in place.放置并调整开关面板总成到安装位置，对准图示6处卡子位置用力按压，确保安装到位。

2. Connect the negative terminal of the 12V battery and start the vehicle. Check that the charging function should work properly2. 连接蓄电池负极，启动车辆。检查充电功能应正常工作