Driver's side lower guard panel assembly驾驶侧下护板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the driver's side lower left decorative panel assembly2. 拆卸驾驶侧左下装饰板总成 Reference: Driver's side lower left decorative panel assembly参考：驾驶侧左下装饰板总成

3. Remove the driver’s side lower cover panel assembly3. 拆卸驾驶侧下护板总成

1 Pry out the hood lock cable handle A.撬出发动机罩锁拉索手柄A。 Recommended tools: Interior parts removal tools推荐工具：内饰件拆卸工具

2 Remove the fixing screw ① and pry out the driver's side lower cover panel assembly with wiring harness.拆卸固定螺钉①，撬出驾驶侧下护板总成带线束。 Recommended tools: Phillips screwdriver, interior parts removal tool推荐工具：十字螺丝刀、内饰件拆卸工具   Note:提示： ♦  Pay attention to the 12 clip positions in the picture.注意图示12处卡子位置。 3 Disconnect the ambient light connector and remove the driver's side lower cover panel assembly.断开氛围灯接插件，取下驾驶侧下护板总成。

Installation procedure安装程序

1. Install the driver's side lower cover panel assembly1. 安装驾驶侧下护板总成 1 Connect the ambient light connector to the driver's side lower cover panel assembly.连接氛围灯接插件到驾驶侧下护板总成。

2 Place and adjust the driver's side lower cover panel assembly to the installation position, align the 12 clip positions shown in the figure and press hard to ensure that the installation is in place, install the fixing screw ① and tighten it.放置并调整驾驶侧下护板总成到安装位置，对准图示12处卡子位置用力按压确保安装到位，安装固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

3 Place and adjust hood lock cable handle A to the installation position.放置并调整发动机罩锁拉索手柄A到安装位置。

2. Install the driver's side lower left decorative panel assembly2. 安装驾驶侧左下装饰板总成 Reference: Driver's side lower left decorative panel assembly参考：驾驶侧左下装饰板总成

3. Connect the negative terminal of the 12V battery3. 连接蓄电池负极