DVD mounting bracketDVD安装支架

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the touch control screen2. 拆卸触摸控制屏 Reference: Touch control screen参考：触摸控制屏

3. Remove the DVD mounting bracket3. 拆卸DVD安装支架

1 Remove 3 fixing bolts ①, 2 fixing screws ②, and remove the DVD mounting bracket.拆卸3颗固定螺栓①、2颗固定螺钉②、取下DVD安装支架。 Recommended tools: 10mm socket ①, Phillips screwdriver ②推荐工具：10mm套筒①，十字螺丝刀②

Installation procedure安装程序

1. Install the DVD mounting bracket1. 安装DVD安装支架

1 Place and adjust the DVD mounting bracket to the installation position, install 3 fixing bolts ① and 2 fixing screws ② and tighten them.放置并调整DVD安装支架到安装位置，安装3颗固定螺栓①、2颗固定螺钉②并紧固。 Recommended tools: 10mm socket ①, Phillips screwdriver ②推荐工具：10mm套筒①，十字螺丝刀② Torque requirement: 6-10N·m①扭矩要求：6-10N•m①

2. Install the touch control panel2. 安装触摸控制屏 Reference: Touch control screen参考：触摸控制屏

3. Connect the negative terminal of the 12V battery and check that the DVD bracket is firmly installed.3. 连接蓄电池负极，检查DVD支架应安装牢固