Left A-pillar upper trim panel assembly左A柱上饰板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the left A-pillar upper trim panel assembly2. 拆卸左A柱上饰板总成

1 Pry open the left A-pillar upper trim panel assembly and remove the left A-pillar upper trim panel assembly with wiring harness.撬开左A柱上饰板总成，移开左A柱上饰板总成带线束。 Recommended tools: clip remover推荐工具：卡扣起子   Note:提示： ♦  Pay attention to the position of the fixing clip and claws in the picture.注意图示固定卡扣、卡爪位置。 2 Disconnect all connectors.断开所有接插件。 3 Remove the driver status monitoring camera.拆卸驾驶员状态监测摄像头。 Reference: Driver condition monitoring camera参考：驾驶员状态监测摄像头 4 Remove the tweeter assembly (left A-pillar).拆卸高音扬声器总成(左A柱)。 Reference: Tweeter assembly (left A-pillar)参考：高音扬声器总成(左A柱)

Installation procedure安装程序

1. Install the left A-pillar upper trim panel assembly1. 安装左A柱上饰板总成 1 Install driver condition monitoring cameras.安装驾驶员状态监测摄像头。 Reference: Driver condition monitoring camera参考：驾驶员状态监测摄像头 2 Install the tweeter assembly (left A-pillar).安装高音扬声器总成(左A柱)。 Reference: Tweeter assembly (left A-pillar)参考：高音扬声器总成(左A柱) 3 Connect all connectors.连接所有接插件。

4 Place and adjust the left A-pillar upper trim panel assembly to the installation position. Fix the claws and clip positions as shown in the figure and press firmly to ensure that the installation is in place.放置并调整左A柱上饰板总成到安装位置，按图示固定卡爪、卡扣位置用力按压，确保安装到位。   Note:提示： ♦  The lip of the tape needs to be turned out and overlapped on the surface of the column.需将胶条唇边翻出，搭接在立柱表面上。

2. Connect the negative terminal of the 12V battery, start the vehicle, and drive away from the maintenance station2. 连接蓄电池负极，启动车辆，驶离维修工位