Instrument panel left end cover assembly仪表板左侧端盖总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the driver's side lower left decorative panel assembly2. 拆卸驾驶侧左下装饰板总成 Reference: Driver's side lower left decorative panel assembly参考：驾驶侧左下装饰板总成

3. Remove the driver’s side lower cover panel assembly3. 拆卸驾驶侧下护板总成 Reference: Driver's side lower cover panel assembly参考：驾驶侧下护板总成

4. Remove the left end cover assembly of the instrument panel4. 拆卸仪表板左侧端盖总成

1 Remove the 2 fixing screws ① and pry out the left end cover assembly of the instrument panel.拆卸2颗固定螺钉①，撬出仪表板左侧端盖总成。 Recommended tools: Phillips screwdriver, trim removal tool推荐工具：十字螺丝刀、饰件拆卸工具   Note:提示： ♦  Pay attention to the 6 clip locations in the picture.注意图示6处卡子位置。

Installation procedure安装程序

1. Install the left end cover assembly of the instrument panel1. 安装仪表板左侧端盖总成

1 Place and adjust the left end cover assembly of the instrument panel to the installation position, align the 6 clips in the figure and press firmly to ensure that it is installed in place, install and tighten the 2 fixing screws ①.放置并调整仪表板左侧端盖总成到安装位置，对准图示6处卡子位置用力按压，确保安装到位，安装2颗固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

2. Install the driver's side lower cover panel assembly2. 安装驾驶侧下护板总成 Reference: Driver's side lower cover panel assembly参考：驾驶侧下护板总成

3. Install the driver's side lower left decorative panel assembly3. 安装驾驶侧左下装饰板总成 Reference: Driver's side lower left decorative panel assembly参考：驾驶侧左下装饰板总成

4. Connect the negative terminal of the 12V battery4. 连接蓄电池负极