Midrange speaker assembly (in dashboard)中音扬声器总成(仪表板中)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the midrange speaker assembly2. 拆卸中音扬声器总成

1 Pry open the speaker mask assembly A.撬开扬声器面罩总成A。 Recommended tools: Interior parts removal tools推荐工具：内饰件拆卸工具   Note:提示： ♦  Pay attention to the positions of the 5 clips in the picture.注意图示5处卡子位置。

2 Remove the 2 fixing screws ① and take out the midrange speaker assembly with wiring harness.拆卸2颗固定螺钉①，取出中音扬声器总成带线束。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

3 Disconnect connector B and remove midrange speaker assembly A.断开接插件B，取下中音扬声器总成A。

Installation procedure安装程序

1. Install midrange speaker assembly1. 安装中音扬声器总成

1 Connect connector B to midrange speaker assembly A.连接接插件B到中音扬声器总成A。

2 Place and adjust the midrange speaker assembly to the installation position, install 2 fixing screws ① and tighten them.放置并调整中音扬声器总成到安装位置，安装2颗固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

3 Place and adjust the speaker mask assembly to installation, align the 5 clip positions shown in the figure and press firmly to ensure that the installation is in place.放置并调整扬声器面罩总成到安装，对准图示5处卡子位置用力按压，确保安装到位。

2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the audio system should work normally.2. 连接蓄电池负极，启动车辆，检查音响系统应正常工作