Front anti-collision beam assembly前防撞梁总成

Removal procedure拆卸程序

1. Preparation1. 准备工作

1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。

2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

3 Lift the vehicle.举升车辆。

2. Remove the upper front guard panel of the front compartment2. 拆卸机舱前上护板

Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Remove the left front wheel arch assembly3. 拆卸左前轮眉总成

Reference: Left front wheel arch trim assembly参考：左前轮眉总成

4. Remove the right front wheel arch assembly4. 拆卸右前轮眉总成

Reference: Right front wheel arch trim assembly参考：右前轮眉总成

5. Remove the front bumper assembly5. 拆卸前保险杠总成

Reference: Front bumper assembly参考：前保险杠总成

Note:提示：

♦

Just remove the front bumper assembly and accessories as a whole without disassembling them.将前保险杠总成及附件整体拆下即可，不必进行拆分。

6. Remove the front-end module central support bracket assembly6. 拆卸前端模块中央支撑支架总成

Reference: Front-end module central support bracket assembly参考：前端模块中央支撑支架总成

7. Remove the filling port7. 拆卸加注口

Reference: Filling port参考：加注口

8. Disassemble the washing kettle assembly8. 拆卸洗涤水壶总成

Reference: Washing kettle assembly参考：洗涤水壶总成

9. Remove the front anti-collision beam assembly9. 拆卸前防撞梁总成

1 Remove 2 fixing bolts ① and 2 fixing nuts ②, and remove the front anti-collision beam assembly.拆卸2颗固定螺栓①、2颗固定螺母②，取下前防撞梁总成。

Recommended tools: 15mm socket推荐工具：15mm套筒

Note:提示：

♦

Take the disassembly on the left side as an example, and do the same on the right side.以左侧拆卸为例，在右侧进行相同操作。

Installation procedure安装程序

1. Install the front anti-collision beam assembly1. 安装前防撞梁总成

1 Place and adjust the front anti-collision beam assembly to the installation position, install 2 fixing bolts ① and 2 fixing nuts ② and tighten them.放置并调整前防撞梁总成到安装位置，安装2颗固定螺栓①、2颗固定螺母②并紧固。

Recommended tools: 15mm socket推荐工具：15mm套筒

Torque requirement: 58–72N·m扭矩要求：58–72N•m