Filling port加注口

Removal procedure拆卸程序

1. Preparation1. 准备工作

1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。

2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成

Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Remove the filling port3. 拆卸加注口

1 Remove the fixing bolt ① and pull out the filling port.拆卸固定螺栓①，拔出加注口。

Recommended tools: 10mm socket推荐工具：10mm套筒

Installation procedure安装程序

1. Install the filling port1. 安装加注口

1 Place and adjust the filling port to the installation position, install the fixing bolt ① and tighten it.放置并调整加注口到安装位置，安装固定螺栓①并紧固。

Recommended tools: 10mm socket推荐工具：10mm套筒

Caution:注意：

♦

Add washing liquid until the liquid level exceeds the connection point. Check that there should be no leakage of washing liquid. Otherwise, the sealing ring should be reinstalled or replaced.加注洗涤液至液面超过连接处，检查应无洗涤液泄漏，否则应重新安装或更换密封圈。

2. Install the front compartment front upper cover panel assembly2. 安装机舱前上护板总成

Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成