Electrical › Car windows/glass/rearview mirrors › Repair
前门限位器总成 · T00609793

 Front door stopper assembly前门限位器总成

  Note:提示:
♦  The disassembly and assembly procedures of the left and right front door stopper assemblies are basically the same. The following content takes the left front door as an example.左、右前门限位器总成的拆装程序基本相同,下述内容以左前门为例进行操作。
Removal procedure拆卸程序
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面,启用驻车制动,使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery断开蓄电池负极
2. Remove the left front door switch panel assembly2. 拆卸左前门开关面板总成
3. Remove the midrange speaker assembly (left front door)3. 拆卸中音扬声器总成(左前门)
4. Remove the inner triangle plate assembly of the left front door4. 拆卸左前门内三角板总成
5. Remove the left front door trim panel assembly5. 拆卸左前门饰板总成
6. Remove the subwoofer assembly (left front door)6. 拆卸重低音扬声器总成(左前门)
7. Remove the front door stopper assembly7. 拆卸前门限位器总成
Graphic
1 Remove the fixing bolts ①, remove the 2 fixing nuts ②, and take out the limiter assembly from inside the door welding assembly.拆卸固定螺栓①,拆卸2颗固定螺母②,从车门焊合总成内部取出限位器总成。
Recommended tools: 10mm socket推荐工具:10mm套筒
Installation procedure安装程序
1. Install the front door stopper assembly1. 安装前门限位器总成
Graphic
1 Place and adjust the front door stopper assembly to the installation position, install 2 fixing nuts ② and tighten them, install and tighten the fixing bolts ①.放置并调整前门限位器总成到安装位置,安装2颗固定螺母②并紧固,安装固定螺栓①并紧固。
Recommended tools: 10mm socket推荐工具:10mm套筒
Torque requirements: 16–20N·m①, 9–11N·m②扭矩要求:16–20N•m①、9–11N•m②
2. Install the subwoofer assembly (left front door)2. 安装重低音扬声器总成(左前门)
3. Install the left front door trim panel assembly3. 安装左前门饰板总成
4. Install the left front door inner triangle panel assembly4. 安装左前门内三角板总成
5. Install the midrange speaker assembly (left front door)5. 安装中音扬声器总成(左前门)
6. Install the left front door switch panel assembly6. 安装左前门开关面板总成
7. Connect the negative terminal of the 12V battery and check that the left front door opens and closes and the limit position should be normal.7. 连接蓄电池负极,检查左前车门开合、限位应正常