ITS to charger water pipe ⅠITS至充电机水管Ⅰ
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
3 Lift the vehicle.举升车辆。
|
|
2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成
|
|
3. Drain the coolant from the temperature control system3. 排放温控系统冷却液
|
|
4. Remove the front compartment front upper cover panel assembly4. 拆卸机舱前上护板总成
|
|
5. Remove the left front wheel arch assembly5. 拆卸左前轮眉总成
|
|
6. Remove the right front wheel arch assembly6. 拆卸右前轮眉总成
|
|
7. Remove the front bumper assembly7. 拆卸前保险杠总成
|
|
8. Remove ITS to charger water pipe Ⅰ8. 拆卸ITS至充电机水管Ⅰ
1 Disengage the pipe fixing clip.脱开管路固定卡。
|
 |
2 Disconnect water pipe connector A.断开水管接头A。
|
 |
3 Disconnect the water pipe joint A and take out the ITS to the charger water pipe I.断开水管接头A，取出ITS至充电机水管Ⅰ。
|
Installation procedure安装程序
|
1. Install ITS to charger water pipe Ⅰ1. 安装ITS至充电机水管Ⅰ
|
|
|
1 Place and adjust the ITS to the charger water pipe I to the installation position, and install the water pipe joint A.放置并调整ITS至充电机水管Ⅰ到安装位置，安装水管接头A。
|
|
|
2 Connect the water pipe connector A.连接水管接头A。
3 Install the pipe fixing card.安装管路固定卡。
|
|
2. Fill the temperature control system coolant2. 加注温控系统冷却液
|
|
3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成
|
|
4. Install front bumper assembly4. 安装前保险杠总成
|
|
5. Install the left front wheel arch trim assembly5. 安装左前轮眉总成
|
|
6. Install the right front wheel arch trim assembly6. 安装右前轮眉总成
|
|
7. Install the front compartment front upper cover panel assembly7. 安装机舱前上护板总成
|
|
8. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift, check that the cooling system should be working normally8. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机，检查冷却系统应正常工作
|