Left rear lower arm assembly (multi-link configuration)左后下臂总成(多连杆配置)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制 动，整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the left rear wheel assembly2. 拆卸左后车轮总成 Reference: Wheel assembly参考：车轮总成

3. Remove the rear floor guard body (multi-link configuration)3. 拆卸后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

4. Remove the rear coil spring (multi-link configuration)4. 拆卸后螺旋弹簧(多连杆配置) Reference: Rear coil spring (multi-link configuration)参考：后螺旋弹簧(多连杆配置)

5. Remove the left rear lower arm assembly5. 拆卸左后下臂总成

1 Remove the fixing nuts and bolts ①, and remove the left rear lower arm assembly.拆卸固定螺母及螺栓①，取下左后下臂总成。 Recommended tools: 21mm socket推荐工具：21mm套筒

Installation procedure安装程序

1. Install the left rear lower arm assembly1. 安装左后下臂总成

1 Place and adjust the left rear lower arm assembly to the installation position, install the fixing bolts and nuts ① and tighten them.放置并调整左后下臂总成到安装位置，安装固定螺栓及螺母①并紧固。 Recommended tools: 21mm socket推荐工具：21mm套筒 Torque requirement: 180-220N·m扭矩要求：180-220N•m

2. Install rear coil spring (multi-link configuration)2. 安装后螺旋弹簧(多连杆配置) Reference: Rear coil spring (multi-link configuration)参考：后螺旋弹簧(多连杆配置)

3. Install the rear floor guard body (multi-link configuration)3. 安装后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

4. Install the left rear wheel assembly4. 安装左后车轮总成 Reference: Wheel assembly参考：车轮总成

5. Carry out four-wheel alignment5. 进行四轮定位 Reference: Four wheel alignment参考：四轮定位

6. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check6. 降落车辆，起动车辆并驶离举升机，路试检查