Rear floor rear lower guard body (multi-link configuration)后地板后下护板本体(多连杆配置)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the rear floor guard body2. 拆卸后地板后下护板本体

1 Remove 13 fixing bolts and 4 fixing screws, and remove the rear floor and rear lower guard body.拆卸13颗固定螺栓、4颗固定螺钉，取下后地板后下护板本体。 Recommended tools: 10mm socket, Phillips screwdriver推荐工具：10mm套筒、十字螺丝刀

Installation procedure安装程序

1. Install the rear floor guard body1. 安装后地板后下护板本体

1 Place and adjust the installed floor rear lower guard body to the installation position, install 13 fixing bolts and 4 fixing screws and tighten them.放置并调整安装后地板后下护板本体到安装位置，安装13颗固定螺栓、4颗固定螺钉并紧固。 Recommended tools: 10mm socket, Phillips screwdriver推荐工具：10mm套筒、十字螺丝刀

2. Check that the rear lower guard panel body of the rear floor should be installed securely.2. 检查后地板后下护板本体应安装牢固

3. Land the vehicle, start the vehicle and drive away from the lift3. 降落车辆，起动车辆并驶离举升机