Outside air temperature sensor assembly外气温度传感器总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。 3 Lift the vehicle.举升车辆。

2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Remove the left front wheel arch assembly3. 拆卸左前轮眉总成 Reference: Left front wheel arch trim assembly参考：左前轮眉总成

4. Remove the right front wheel arch assembly4. 拆卸右前轮眉总成 Reference: Right front wheel arch trim assembly参考：右前轮眉总成

5. Remove the front bumper assembly5. 拆卸前保险杠总成 Reference: Front bumper assembly参考：前保险杠总成

6. Remove the outside air temperature sensor assembly6. 拆卸外气温度传感器总成

1 Disconnect connector A and pry out the outside air temperature sensor assembly.断开接插件A，撬出外气温度传感器总成。 Recommended tools: clip remover推荐工具：卡扣起子

Installation procedure安装程序

1. Install the outside air temperature sensor assembly1. 安装外气温度传感器总成

1 Place and adjust the outside air temperature sensor assembly to the installation position, and connect connector A.放置并调整外气温度传感器总成到安装位置，连接接插件A。

2. Install the front bumper assembly2. 安装前保险杠总成 Reference: Front bumper assembly参考：前保险杠总成

3. Install the right front wheel arch trim assembly3. 安装右前轮眉总成 Reference: Right front wheel arch trim assembly参考：右前轮眉总成

4. Install left front wheel arch assembly4. 安装左前轮眉总成 Reference: Left front wheel arch trim assembly参考：左前轮眉总成

5. Install the front compartment front upper cover panel assembly5. 安装机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

6. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift, check that the outside air temperature sensor assembly should work normally6. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机，检查外气温度传感器总成应正常工作