Blind spot monitoring main sensor盲区监测主传感器

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。 3 Lift the vehicle.举升车辆。

2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Remove the left front wheel arch assembly3. 拆卸左前轮眉总成 Reference: Left front wheel arch trim assembly参考：左前轮眉总成

4. Remove the right front wheel arch assembly4. 拆卸右前轮眉总成 Reference: Right front wheel arch trim assembly参考：右前轮眉总成

5. Remove the front bumper assembly5. 拆卸前保险杠总成 Reference: Front bumper assembly参考：前保险杠总成

6. Disassemble the main sensor for blind spot monitoring6. 拆卸盲区监测主传感器

1 Disconnect connector A, pry out the three fixing cards ①, and take out the blind spot monitoring main sensor.断开接插件A，撬出3颗固定卡①，取出盲区 监测主传感器。 Recommended tools: clip remover推荐工具：卡扣起子

Installation procedure安装程序

1. Install the main sensor for blind spot monitoring1. 安装盲区监测主传感器

1 Place and adjust the main blind spot monitoring sensor to the installation position, install 3 fixing cards ①, and connect connector A.放置并调整盲区监测主传感器到安装位置，安装3颗固定卡①，连接接插件A。

2. Install the front bumper assembly2. 安装前保险杠总成 Reference: Front bumper assembly参考：前保险杠总成

3. Install the right front wheel arch trim assembly3. 安装右前轮眉总成 Reference: Right front wheel arch trim assembly参考：右前轮眉总成

4. Install left front wheel arch assembly4. 安装左前轮眉总成 Reference: Left front wheel arch trim assembly参考：左前轮眉总成

5. Install the front compartment front upper cover panel assembly5. 安装机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

6. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift, and check that the main sensor for blind spot monitoring should be working normally.6. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机，检查盲区监测主传感器应正常工作