Airbag electronic control unit安全气囊电控单元
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the driver's side lower left decorative panel assembly2. 拆卸驾驶侧左下装饰板总成
|
|
3. Remove the driver’s side lower cover panel assembly3. 拆卸驾驶侧下护板总成
|
|
4. Remove the passenger side lower right decorative panel assembly4. 拆卸副驾驶侧右下装饰板总成
|
|
5. Remove the left front extension plate assembly5. 拆卸左前延伸板总成
|
|
6. Remove the right front extension plate assembly6. 拆卸右前延伸板总成
|
|
7. Remove the switch panel assembly7. 拆卸开关面板总成
|
|
8. Remove the sub-instrument panel body assembly8. 拆卸副仪表板本体总成
|
|
9. Remove the airbag electronic control unit9. 拆卸安全气囊电控单元
|
 |
1 Disconnect connectors A and B, remove 3 fixing bolts ①, and remove the airbag electronic control unit.断开接插件A、B，拆卸3颗固定螺栓①，取下安全气囊电控单元。
|
Installation procedure安装程序
|
1. Install the airbag electronic control unit1. 安装安全气囊电控单元
|
|
|
1 Place and adjust the airbag electronic control unit to the installation position, install and tighten 3 fixing bolts ①, and connect connectors A and B.放置并调整安全气囊电控单元到安装位置，安装3颗固定螺栓①并紧固，连接接插件A、B。
|
|
2. Install the sub-instrument panel body assembly2. 安装副仪表板本体总成
|
|
3. Install the switch panel assembly3. 安装开关面板总成
|
|
4. Install right front extension panel assembly4. 安装右前延伸板总成
|
|
5. Install the left front extension plate assembly5. 安装左前延伸板总成
|
|
6. Install the passenger side lower right decorative panel assembly6. 安装副驾驶侧右下装饰板总成
|
|
7. Install the driver’s side lower cover panel assembly7. 安装驾驶侧下护板总成
|
|
8. Install the driver's side lower left decorative panel assembly8. 安装驾驶侧左下装饰板总成
|
|
9. Connect the negative terminal of the 12V battery, start the vehicle, use the diagnostic tool to check the airbag system, and clear the fault code9. 连接蓄电池负极，启动车辆，使用诊断仪检查安全气囊系统，清除故障码
|