Left front combination light左前组合灯
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
3 Lift the vehicle.举升车辆。
|
|
2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成
|
|
3. Remove the left front wheel arch assembly3. 拆卸左前轮眉总成
|
|
4. Remove the right front wheel arch assembly4. 拆卸右前轮眉总成
|
|
5. Remove the front bumper assembly5. 拆卸前保险杠总成
|
|
6. Remove the left front combination lamp6. 拆卸左前组合灯
1 Disconnect the left front combination light connector.断开左前组合灯接插件。
|
 |
2 Remove the 3 fixing bolts ①.拆卸3颗固定螺栓①。
|
 |
3 Remove 1 fixing bolt ① and remove the left front combination lamp.拆卸1颗固定螺栓①，取下左前组合灯。
|
Installation procedure安装程序
|
1. Install the left front combination light1. 安装左前组合灯
|
|
|
1 Place and adjust the left front combination light to the installation position, install 1 fixing bolt ① and tighten it.放置并调整左前组合灯到安装位置，安装1颗固定螺栓①并紧固。
|
|
|
2 Install the 3 fixing bolts ① and tighten them.安装3颗固定螺栓①并紧固。
3 Connect the left front combination light connector.连接左前组合灯接插件。
|
|
2. Install the front bumper assembly2. 安装前保险杠总成
|
|
3. Install the right front wheel arch trim assembly3. 安装右前轮眉总成
|
|
4. Install left front wheel arch assembly4. 安装左前轮眉总成
|
|
5. Install the front compartment front upper cover panel assembly5. 安装机舱前上护板总成
|
|
6. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle, and check that the left front combination light should work normally.6. 降落车辆，连接蓄电池负极，启动车辆，检查左前组合灯应正常工作
|