|
|
NOTE： |
|
♦
|
The disassembly and assembly procedures for the left and right rear wheel hub bearings are basically the same. The following content takes the left side as an example.左、右后轮毂轴承的拆装程序基本相同，下述内容以左侧为例进行操作。 |
|
|
Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, release the parking brake or put it in maintenance mode, and the vehicle power supply is in "OFF" state.将车辆驶入举升机举升位置，解除驻车制动或使其处于维修模式，整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
|
2. Remove the left rear wheel assembly2. 拆卸左后车轮总成
|
|
|
3. Remove the left rear brake disc3. 拆卸左后制动盘
|
|
|
4. Remove the left rear in-line wheel speed sensor4. 拆卸左后直插式轮速传感器
|
|
|
5. Remove the rear hub bearing5. 拆卸后轮毂轴承
|
|
|
1 Remove the 4 fixing bolts ①, and remove the rear hub bearing A and the left rear brake disc dust cover B.拆卸4颗固定螺栓①，取下后轮毂轴承A、左后制动盘防尘罩B。
|
|
Recommended tools: H10 socket推荐工具：H10套筒 |
|
Installation procedure安装程序
|
|
1. Install rear hub bearing1. 安装后轮毂轴承
|
|
|
1 Place and adjust the left rear brake disc dust cover B and rear hub bearing A to the installation position, install 4 fixing bolts ① and tighten them.放置并调整左后制动盘防尘罩B、后轮毂轴承A到安装位置，安装4颗固定螺栓①并紧固。
|
|
Recommended tools: H10 socket推荐工具：H10套筒 |
|
|
Torque requirement: 90-110N·m扭矩要求：90-110N•m |
|
|
|
2. Install the left rear in-line wheel speed sensor2. 安装左后直插式轮速传感器
|
|
|
3. Install the left rear brake disc3. 安装左后制动盘
|
|
|
4. Install the left rear wheel assembly4. 安装左后车轮总成
|
|
|
5. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check5. 降落车辆，起动车辆并驶离举升机，路试检查
|
Rear hub bearing后轮毂轴承
