|
|
NOTE： |
|
♦
|
The disassembly and assembly procedures for the left and right rear brake discs are basically the same. The following content takes the left side as an example.左、右后制动盘的拆装程序基本相同，下述内容以左侧为例进行操作。 |
|
|
Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, release the parking brake or put it in maintenance mode, and the vehicle power supply is in "OFF" state.将车辆驶入举升机举升位置，解除驻车制动或使其处于维修模式，整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
|
2. Remove the left rear wheel assembly2. 拆卸左后车轮总成
|
|
|
3. Remove the rear brake disc3. 拆卸后制动盘
|
|
|
1 Remove the 2 fixing bolts ① and remove the motor-integrated left rear caliper assembly A.拆卸2颗固定螺栓①，取下电机集成式左后卡钳总成A。
|
|
Recommended tools: 18mm socket推荐工具：18mm套筒 |
|
|
CAUTION： |
|
♦
|
After removing the rear brake caliper, use iron wire to hang it to the body to avoid stress on the brake hose and wiring harness.取下后制动卡钳后，使用铁丝将其悬挂至车身，避免制动软管及线束受力。 |
|
|
|
|
|
2 Remove the fixing screw ① and remove the rear brake disc A.拆卸固定螺钉①，取下后制动盘A。
|
|
Recommended tools: T30 socket推荐工具：T30套筒 |
|
|
|
CAUTION： |
|
♦
|
Be careful when removing the rear brake disc to avoid damage to the brake disc due to falling, or even personal injury.取下后制动盘时应谨慎操作，避免制动盘因掉落而损坏，甚至造成人员受伤。 |
|
|
|
Installation procedure安装程序
|
|
1. Install rear brake disc1. 安装后制动盘
|
|
|
1 Place and adjust the rear brake disc A to the installation position, install the fixing screw ① and tighten it.放置并调整后制动盘A到安装位置，安装固定螺钉①并紧固。
|
|
Recommended tools: T30 socket推荐工具：T30套筒 |
|
|
|
CAUTION： |
|
♦
|
Be careful when installing the rear brake disc to avoid damage to the brake disc due to falling, or even personal injury.安装后制动盘时应谨慎操作，避免制动盘因掉落而损坏，甚至造成人员受伤。 |
|
|
|
|
|
2 Place and adjust the motor-integrated left rear caliper assembly A to the installation position, install and fix the 2 fixing bolts ① and tighten.放置并调整电机集成式左后卡钳总成A到安装位置，安装固定2颗固定螺栓①并紧固。
|
|
Recommended tools: 18mm socket推荐工具：18mm套筒 |
|
|
Torque requirement: 100-120N·m扭矩要求：100-120N•m |
|
|
|
2. Install the left rear wheel assembly2. 安装左后车轮总成
|
|
|
3. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check3. 降落车辆，起动车辆并驶离举升机，路试检查
|
Rear brake disc后制动盘
