Rear and front toe arm assembly (multi-link configuration)

Note:提示：

♦

The disassembly and assembly procedures for the left and right rear toe arm assemblies (multi-link configuration) are basically the same. The following content takes the left side as an example.左、右后前束臂总成(多连杆配置)的拆装程序基本相同，下述内容以左侧为例进行操作。

1. Preparation1. 准备工作

1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。

2 Lift the vehicle.举升车辆。

2. Remove the left rear wheel assembly2. 拆卸左后车轮总成

Reference: Wheel assembly参考：车轮总成

3. Remove the rear floor guard body (multi-link configuration)3. 拆卸后地板后下护板本体(多连杆配置)

Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

4. Remove the rear front toe arm assembly4. 拆卸后前束臂总成

1 Remove the 2 fixing nuts and bolts ①, and remove the rear front toe arm assembly.拆卸2颗固定螺母及螺栓①，取下后前束臂总成。

Recommended tools: 18mm socket推荐工具：18mm套筒

1. Install the rear front toe arm assembly1. 安装后前束臂总成

1 Place and adjust the rear front toe arm assembly to the installation position, install 2 fixing bolts and nuts ① and tighten them.放置并调整后前束臂总成到安装位置，安装2颗固定螺栓及螺母①并紧固。

Recommended tools: 18mm socket推荐工具：18mm套筒

Torque requirement: 115-135N·m扭矩要求：115-135N•m

2. Install the rear cover panel and rear lower cover panel assembly (multi-link configuration)2. 安装后护板后下护板总成(多连杆配置)

Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

3. Install the left rear wheel assembly3. 安装左后车轮总成

Reference: Wheel assembly参考：车轮总成

4. Carry out four-wheel alignment4. 进行四轮定位

Reference: Four wheel alignment参考：四轮定位

5. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check5. 降落车辆，起动车辆并驶离举升机，路试检查

Rear and front toe arm assembly (multi-link configuration)后前束臂总成(多连杆配置)