|
|
Note:提示： |
|
♦
|
The disassembly and assembly procedures for the left and right rear lower trailing arm assemblies (multi-link configuration) are basically the same. The following content takes the left side as an example.左、右后下纵臂总成(多连杆配置)的拆装程序基本相同，下述内容以左侧为例进行操作。 |
|
|
Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
|
2. Remove the left rear wheel assembly2. 拆卸左后车轮总成
|
|
|
3. Remove the rear floor guard body (multi-link configuration)3. 拆卸后地板后下护板本体(多连杆配置)
|
|
|
4. Remove the rear lower trailing arm assembly4. 拆卸后下纵臂总成
|
|
|
1 Remove the 2 fixing nuts and bolts ①, and remove the rear lower trailing arm assembly.拆卸2颗固定螺母及螺栓①，取下后下纵臂总成。
|
|
Recommended tools: 21mm socket推荐工具：21mm套筒 |
|
Installation procedure安装程序
|
|
1. Install the rear lower trailing arm assembly1. 安装后下纵臂总成
|
|
|
1 Place and adjust the rear lower trailing arm assembly to the installation position, install 2 fixing bolts and nuts ① and tighten them.放置并调整后下纵臂总成到安装位置，安装2颗固定螺栓及螺母①并紧固。
|
|
Recommended tools: 21mm socket推荐工具：21mm套筒 |
|
|
Torque requirement: 180-220N·m扭矩要求：180-220N•m |
|
|
|
2. Install the left rear wheel assembly2. 安装左后车轮总成
|
|
|
3. Install the rear cover panel and rear lower cover panel assembly (multi-link configuration)3. 安装后护板后下护板总成(多连杆配置)
|
|
|
4. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check4. 降落车辆，起动车辆并驶离举升机，路试检查
|
Rear lower trailing arm assembly (multi-link configuration)后下纵臂总成(多连杆配置)
