Battery high-voltage wiring harness I (battery-swap version)电池高压线束Ⅰ(换电版)
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
3 Lift the vehicle.举升车辆。
|
|
2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成
|
|
3. Disassemble the battery pack assembly (battery-swap version)3. 拆卸电池组箱总成(换电版)
|
|
4. Remove the battery high-voltage wiring harness Ⅰ4. 拆卸电池高压线束Ⅰ
|
 |
1 Disconnect connector A.断开接插件A。
|
 |
2 Remove the grounding bolt ① and disconnect connectors A and B.拆卸接地螺栓①，断开接插件A、B。
|
 |
3 Remove the 4 fixing bolts ①.拆卸4颗固定螺栓①。
4 Pry open the wiring harness fixing card and remove the battery high-voltage wiring harness I.撬开线束固定卡，取下电池高压线束Ⅰ。
|
Installation procedure安装程序
|
1. Install battery high-voltage wiring harness Ⅰ1. 安装电池高压线束Ⅰ
1 Place and adjust the battery high-voltage wire harness I to the installation position, and install the wire harness fixing card.放置并调整电池高压线束Ⅰ到安装位置，安装线束固定卡。
|
|
|
2 Install the high-voltage wiring harness bracket to the body, install 4 fixing bolts ① and tighten them.安装高压线束支架到车身，安装4颗固定螺栓①并紧固。
|
|
|
3 Connect connectors A and B, install grounding bolt ① and tighten.连接接插件A、B，安装接地螺栓①并紧固。
|
|
|
4 Connect connector A.连接接插件A。
|
|
2. Install the battery pack assembly (battery-swap version)2. 安装电池组箱总成(换电版)
|
|
3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成
|
|
4. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift4. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机
|