Hatchback door lower trim panel assembly掀背门下饰板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the hatchback door handle box assembly2. 拆卸掀背门拉手盒总成 Reference: Hatchback door handle box assembly参考：掀背门拉手盒总成

3. Remove liftgate switch3. 拆卸举升门开关 Reference: Liftgate switch参考：举升门开关

4. Remove the hatchback door lower trim panel assembly4. 拆卸掀背门下饰板总成

1 Pry out the hatchback door lower trim panel assembly A.撬出掀背门下饰板总成A。 Recommended tools: clip remover推荐工具：卡扣起子   Note:提示： ♦  Pay attention to the 14 clip positions in the picture.注意图示14处卡扣位置。

Installation procedure安装程序

1. Install the hatchback door lower trim panel assembly1. 安装掀背门下饰板总成

1 Place and adjust the hatchback door lower trim panel assembly A to the installation position, align the 14 clip positions shown in the figure and press firmly to ensure that it is installed in place.放置并调整掀背门下饰板总成A到安装位置，对准图示14处卡扣位置用力按压，确保安装到位。

2. Install liftgate switch2. 安装举升门开关 Reference: Liftgate switch参考：举升门开关

3. Install the hatchback door handle box assembly3. 安装掀背门拉手盒总成 Reference: Hatchback door handle box assembly参考：掀背门拉手盒总成

4. Connect the negative terminal of the 12V battery4. 连接蓄电池负极