Vehicle controller整车控制器

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the high voltage distribution box2. 拆卸高压配电盒 Reference: High Voltage Distribution Box参考：高压配电盒

3. Remove the high-voltage wiring harness bracket I3. 拆卸高压线束支架I Reference: High voltage wire harness bracket I参考：高压线束支架I

4. Disassemble the vehicle controller4. 拆卸整车控制器

1 Disconnect connectors A and B, remove 4 fixing nuts ①, and remove the vehicle controller.断开接插件A、B，拆卸4颗固定螺母①，取下整车控制器。 Recommended tools: 10mm socket推荐工具：10mm套筒

Installation procedure安装程序

1. Install vehicle controller1. 安装整车控制器

1 Place and adjust the vehicle controller to the installation position, install and tighten 4 fixing nuts ①, and connect connectors A and B.放置并调整整车控制器到安装位置，安装4颗固定螺母①并紧固，连接接插件A、B。 Recommended tools: 10mm socket推荐工具：10mm套筒 Torque requirement: 6-10N·m扭矩要求：6-10N•m

2. Install the high-voltage wiring harness bracket I2. 安装高压线束支架I Reference: High voltage wire harness bracket I参考：高压线束支架I

3. Install high-voltage distribution box3. 安装高压配电盒 Reference: High Voltage Distribution Box参考：高压配电盒

4. Connect the negative terminal of the 12V battery, start the vehicle, use the diagnostic tool to check the vehicle control system, and clear the fault code4. 连接蓄电池负极，启动车辆，使用诊断仪检查整车控制系统，清除故障码