Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
|
2. Remove the high voltage distribution box2. 拆卸高压配电盒
|
|
|
1 Remove the fixing bolt ①, remove the grounding harness A, and disconnect connectors B, C, D, and E.拆卸固定螺栓①，移开接地线束A，断开接插件B、C、D、E。
|
|
Recommended tools: 13mm socket推荐工具：13mm套筒 |
|
|
|
2 Remove the 4 fixing nuts ① and take out the high-voltage distribution box A.拆卸4颗固定螺母①，取出高压配电盒A。
|
|
Recommended tools: 10mm socket推荐工具：10mm套筒 |
|
Installation procedure安装程序
|
|
1. Install high voltage distribution box1. 安装高压配电盒
|
|
|
1 Place and adjust the high-voltage distribution box A to the installation position, install 4 fixing nuts ① and tighten them.放置并调整高压配电盒A到安装位置，安装4颗固定螺母①并紧固。
|
|
Recommended tools: 10mm socket推荐工具：10mm套筒 |
|
|
Torque requirement: 6-10N·m扭矩要求：6-10N•m |
|
|
|
2 Connect connectors B, C, D, and E, connect the grounding harness A, install the fixing bolt ① and tighten it.连接接插件B、C、D、E，连接接地线束A，安装固定螺栓①并紧固。
|
|
Recommended tools: 13mm socket推荐工具：13mm套筒 |
|
|
Torque requirement: 20-24N·m扭矩要求：20-24N•m |
|
|
|
2. Connect the negative terminal of the 12V battery and check that the vehicle should be powered on and off normally.2. 连接蓄电池负极，检查车辆应正常整车上下电
|
High voltage distribution box高压配电盒
