High voltage wire harness bracket I高压线束支架I

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the high voltage distribution box2. 拆卸高压配电盒 Reference: High Voltage Distribution Box参考：高压配电盒

3. Remove the high-voltage wiring harness bracket I3. 拆卸高压线束支架I

1 Remove the 4 fixing nuts ① and take out the high-voltage harness bracket IA.拆卸4颗固定螺母①，取出高压线束支架IA。 Recommended tools: 10mm socket推荐工具：10mm套筒

Installation procedure安装程序

1. Install the high-voltage wiring harness bracket I1. 安装高压线束支架I

1 Place and adjust the high-voltage wire harness bracket IA to the installation position, install 4 fixing nuts ① and tighten them.放置并调整高压线束支架IA到安装位置，安装4颗固定螺母①并紧固。 Recommended tools: 10mm socket推荐工具：10mm套筒 Torque requirement: 6-10N·m扭矩要求：6-10N•m

2. Install high-voltage distribution box2. 安装高压配电盒 Reference: High Voltage Distribution Box参考：高压配电盒

3. Connect the negative terminal of the 12V battery and check that the vehicle should be powered on and off normally.3. 连接蓄电池负极，检查车辆应正常整车上下电