Quick water change connector快换水连接器

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。 3 Lift the vehicle.举升车辆。

2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

3. Drain the coolant from the temperature control system3. 排放温控系统冷却液 Reference: Temperature control system coolant参考：温控系统冷却液

4. Disassemble the battery pack assembly (battery-swap version)4. 拆卸电池组箱总成(换电版) Reference: Battery pack assembly (battery-swap version)参考：电池组箱总成(换电版)

5. Disassemble the quick-change water connector5. 拆卸快换水连接器

1 Remove the 4 fixing bolts ①, disconnect water pipes A and B, and remove the quick-change water connector.拆卸4颗固定螺栓①，断开水管A、B，取下快换水连接器。 Recommended tools: H6 hex socket推荐工具：H6内六角套筒

Installation procedure安装程序

1. Install the quick-change water connector1. 安装快换水连接器

1 Connect water pipes A and B to the quick-change water connector, place and adjust the quick-change water connector to the installation position, install 4 fixing bolts ① and tighten them.连接水管A、B到快换水连接器，放置并调整快换水连接器到安装位置，安装4颗固定螺栓①并紧固。 Recommended tools: H6 hex socket推荐工具：H6内六角套筒

2. Install the battery pack assembly (battery-swap version)2. 安装电池组箱总成(换电版) Reference: Battery pack assembly (battery-swap version)参考：电池组箱总成(换电版)

3. Fill the temperature control system coolant3. 加注温控系统冷却液 Reference: Temperature control system coolant参考：温控系统冷却液

4. Install the front compartment front lower cover panel assembly4. 安装机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

5. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift, check that the cooling system should be working normally5. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机，检查冷却系统应正常工作