Rear floor pan support后地板底护板支架
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
2. Remove the rear floor front lower guard body2. 拆卸后地板前下护板本体
|
|
3. Remove the rear floor guard body3. 拆卸后地板后下护板本体
|
|
4. Remove the rear floor panel bracket4. 拆卸后地板底护板支架
|
 |
1 Remove the 10 fixing nuts ① and remove the rear floor panel bracket.拆卸10颗固定螺母①，取下后地板底护板支架。
|
Installation procedure安装程序
|
1. Install the rear floor panel bracket1. 安装后地板底护板支架
|
|
|
1 Place and adjust the installed floor bottom guard bracket to the installation position, install 10 fixing nuts ① and tighten them.放置并调整安装后地板底护板支架到安装位置，安装10颗固定螺母①并紧固。
|
|
2. Install the rear floor guard body2. 安装后地板后下护板本体
|
|
3. Install the rear floor and front lower guard body3. 安装后地板前下护板本体
|
|
4. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check4. 降落车辆，起动车辆并驶离举升机，路试检查
|