Rear floor rear lower guard body后地板后下护板本体

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the rear floor front lower guard body2. 拆卸后地板前下护板本体 Reference: Rear floor and front lower guard body参考：后地板前下护板本体

3. Remove the rear floor guard body3. 拆卸后地板后下护板本体

1 Remove 11 fixing bolts ①.拆卸11颗固定螺栓①。 Recommended tools: 10mm socket推荐工具：10mm套筒

2 Remove the 4 fixing screws ① and take off the rear floor panel body.拆卸4颗固定螺钉①，取下后地板后下护板本体。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

Installation procedure安装程序

1. Install the rear floor guard body1. 安装后地板后下护板本体

1 Place and adjust the body of the rear lower guard plate of the installed floor to the installation position, install 11 fixing bolts ① and tighten them.放置并调整安装后地板后下护板本体到安装位置，安装11颗固定螺栓①并紧固。 Recommended tools: 10mm socket推荐工具：10mm套筒

2 Install the 4 fixing screws ① and tighten them.安装4颗固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

2. Install the rear floor and front lower guard body2. 安装后地板前下护板本体 Reference: Rear floor and front lower guard body参考：后地板前下护板本体

3. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check3. 降落车辆，起动车辆并驶离举升机，路试检查