Right front brake pipe右前制动硬管
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
2. Remove the right front wheel assembly2. 拆卸右前车轮总成
|
|
3. Drain brake fluid3. 排放制动液
|
|
4. Remove the front compartment front lower cover panel assembly4. 拆卸机舱前下护板总成
|
|
5. Remove the right front brake pipe5. 拆卸右前制动硬管
|
 |
1 Remove the oil pipe joint nut ① and disconnect the right front brake pipe A from the right front brake hose assembly.拆卸油管接头螺母①，断开右前制动硬管A与右前制动软管总成的连接。
|
 |
2 Remove the oil pipe joint nut ① and disconnect the right front brake pipe from the integrated brake control system.拆卸油管接头螺母①，断开右前制动硬管与集成式制动控制系统的连接。
3 Disengage the pipe fixing clip and take out the right front brake pipe.脱开管路固定卡，取出右前制动硬管。
|
Installation procedure安装程序
|
1. Install the right front brake pipe1. 安装右前制动硬管
1 Place and adjust the right front brake pipe to the installation position, and install the pipe fixing card.放置并调整右前制动硬管到安装位置，安装管路固定卡。
|
|
|
2 Install the right front brake pipe to the integrated brake control system, install the oil pipe joint nut ① and tighten it.安装右前制动硬管到集成式制动控制系统，安装油管接头螺母①并紧固。
|
|
|
3 Install the right front brake pipe A to the right front brake hose assembly, install the oil pipe joint nut ① and tighten it.安装右前制动硬管A到右前制动软管总成，安装油管接头螺母①并紧固。
|
|
2. Install the right front wheel assembly2. 安装右前车轮总成
|
|
3. Add brake fluid and bleed air3. 加注制动液并排气
|
|
4. Install the front compartment front lower cover panel assembly4. 安装机舱前下护板总成
|
|
5. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check5. 降落车辆，起动车辆并驶离举升机，路试检查
|