Rear floor underbody guard bracket (multi-link configuration)后地板底护板支架(多连杆配置)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the rear floor and front lower guard body (multi-link configuration)2. 拆卸后地板前下护板本体(多连杆配置) Reference: Rear floor and front lower guard body (multi-link configuration)参考：后地板前下护板本体(多连杆配置)

3. Remove the rear floor guard body (multi-link configuration)3. 拆卸后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

4. Remove the rear floor panel bracket4. 拆卸后地板底护板支架

1 Remove the 8 fixing bolts ① and remove the rear floor bottom guard bracket.拆卸8颗固定螺栓①，取下后地板底护板支架。 Recommended tools: 10mm socket推荐工具：10mm套筒

Installation procedure安装程序

1. Install the rear floor panel bracket1. 安装后地板底护板支架

1 Place and adjust the installed floor bottom guard bracket to the installation position, install 8 fixing nuts ① and tighten them.放置并调整安装后地板底护板支架到安装位置，安装8颗固定螺母①并紧固。 Recommended tools: 10mm socket推荐工具：10mm套筒

2. Install the rear floor guard body (multi-link configuration)2. 安装后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

3. Install the rear floor and front lower guard body (multi-link configuration)3. 安装后地板前下护板本体(多连杆配置) Reference: Rear floor and front lower guard body (multi-link configuration)参考：后地板前下护板本体(多连杆配置)

4. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check4. 降落车辆，起动车辆并驶离举升机，路试检查