Rear subframe front mounting bracket (multi-link configuration)后副车架前安装支架(多连杆配置)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the rear floor guard body (multi-link configuration)2. 拆卸后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

3. Remove the rear subframe front mounting bracket3. 拆卸后副车架前安装支架

1 Use a hydraulic lifting platform truck to firmly support the rear subframe assembly (multi-link configuration). Remove the fixing bolts ① and ②, and remove the front mounting bracket of the rear subframe.使用液压升降平台车稳固支撑后副车架总成(多连杆配置)。拆卸固定螺栓①、固定螺栓②，取下后副车架前安装支架。 Recommended tools: 18mm sleeve ①, 21mm sleeve ②, hydraulic lifting platform truck推荐工具：18mm套筒①、21mm套筒②、液压升降平台车

Installation procedure安装程序

1. Install the rear subframe and front mounting bracket1. 安装后副车架前安装支架

1 Place and adjust the front mounting bracket of the rear subframe to the installation position, install and tighten the fixing bolts ② and ①, and slowly lower the hydraulic lifting platform vehicle.放置并调整后副车架前安装支架到安装位置，安装固定螺栓②、固定螺栓①并紧固，缓慢降下液压升降平台车。 Recommended tools: 18mm sleeve ①, 21mm sleeve ②, hydraulic lifting platform truck推荐工具：18mm套筒①、21mm套筒②、液压升降平台车 Torque requirements: 80-100N·m①, 190-210N·m②扭矩要求：80-100N•m①、190-210N•m②

2. Install the rear floor guard body (multi-link configuration)2. 安装后地板后下护板本体(多连杆配置) Reference: Rear floor rear lower guard body (multi-link configuration)参考：后地板后下护板本体(多连杆配置)

3. Lower the lift and drive the vehicle away from the lift3. 降落举升机，将车辆驶离举升机