Left rear transverse stabilizer rod assembly (multi-link suspension)左后横向稳定杆拉杆总成(多连杆悬架)

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the left rear wheel assembly2. 拆卸左后车轮总成 Reference: Wheel assembly参考：车轮总成

3. Remove the left rear transverse stabilizer rod assembly3. 拆卸左后横向稳定杆拉杆总成

1 Remove the fixing bolt ①. Fix the nut ② and remove the left rear transverse stabilizer rod assembly.拆卸固定螺栓①。固定螺母②，取下左后横向稳定杆拉杆总成。 Recommended tools: 21mm socket ①, 18mm socket ②推荐工具：21mm套筒①、18mm套筒②

Installation procedure安装程序

1. Install the left rear transverse stabilizer rod assembly1. 安装左后横向稳定杆拉杆总成

1 Place and adjust the left rear transverse stabilizer rod assembly to the installation position, install the fixing bolt ① and the fixing nut ② and tighten them.放置并调整左后横向稳定杆拉杆总成到安装位置，安装固定螺栓①、固定螺母②并紧固。 Recommended tools: 21mm socket ①, 18mm socket ②推荐工具：21mm套筒①、18mm套筒② Torque requirements: 180-220N·m①, 99-121N·m②扭矩要求：180-220N•m①、99-121N•m②

2. Install the left rear wheel assembly2. 安装左后车轮总成 Reference: Wheel assembly参考：车轮总成

3. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check3. 降落车辆，起动车辆并驶离举升机，路试检查