Forward looking binocular camera前视双目摄像头

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Disassemble the endoscope assembly4. 拆卸内视镜总成 Reference: Endoscope assembly参考：内视镜总成

5. Disassemble the front-view binocular camera5. 拆卸前视双目摄像头

1 Push up the four claws ①, disconnect connectors A and B, and pry out the front-view binocular camera.向上推动4个卡爪①，断开接插件A、B，撬出前视双目摄像头。 Recommended tools: clip remover推荐工具：卡扣起子

Installation procedure安装程序

1. Install front-view binocular camera1. 安装前视双目摄像头

1 Place and adjust the front-view binocular camera to the installation position, push down the four claws ①, and connect connectors A and B.放置并调整前视双目摄像头到安装位置，向下推动4个卡爪①，连接接插件A、B。

2. Install the endoscope assembly2. 安装内视镜总成 Reference: Endoscope assembly参考：内视镜总成

3. Install the decorative cover under the endoscope3. 安装内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Install decorative cover on endoscope4. 安装内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

5. Connect the negative terminal of the 12V battery, start the vehicle, and check that the forward-looking binocular camera should work normally.5. 连接蓄电池负极，起动车辆，检查前视双目摄像头应正常工作