Endoscope assembly内视镜总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Disassemble the endoscope assembly4. 拆卸内视镜总成 1 Disconnect the endoscope assembly connector.断开内视镜总成接插件。

2 Remove the fixing screw ① and take off the endoscope assembly.拆卸固定螺钉①，取下内视镜总成。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

Installation procedure安装程序

1. Install the endoscope assembly1. 安装内视镜总成

1 Place and adjust the endoscope assembly to the installation position, install the fixing screw ① and tighten it.放置并调整内视镜总成到安装位置，安装固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀   Note:提示： ♦  Shake the endoscope assembly to confirm that the endoscope is installed in place.晃动内视镜总成，确认内视镜已安装到位。 2 Connect the endoscope assembly connector.连接内视镜总成接插件。

2. Install the decorative cover under the endoscope2. 安装内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

3. Install the decorative cover on the interior mirror3. 安装内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

4. Connect the negative terminal of the 12V battery, start the vehicle, and check that the interior mirror assembly should work normally.4. 连接蓄电池负极，启动车辆，检查内视镜总成应正常工作