Front bumper camera assembly前保险杠摄像头总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Remove the front bumper camera assembly3. 拆卸前保险杠摄像头总成 1 Disconnect the connector.断开接插件。

2 Remove the 3 fixing screws ① and remove the front bumper camera assembly.拆卸3颗固定螺钉①，取下前保险杠摄像头总成。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

Installation procedure安装程序

1. Install the front bumper camera assembly1. 安装前保险杠摄像头总成

1 Place and adjust the front bumper camera assembly to the installation position, install 3 fixing screws ① and tighten.放置并调整前保险杠摄像头总成到安装位置，安装3颗固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀 2 Connect the connector to the front bumper camera assembly.连接接插件到前保险杠摄像头总成。

2. Install the front compartment front upper cover panel assembly2. 安装机舱前上护板总成 Reference: Front compartment front upper cover panel assembly参考：机舱前上护板总成

3. Connect the negative terminal of the 12V battery, start the vehicle, and check that the front bumper camera assembly should work normally.3. 连接蓄电池负极，起动车辆，检查前保险杠摄像头总成应正常工作