GPS antenna assemblyGPS天线总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the decorative cover on the interior mirror2. 拆卸内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

3. Remove the decorative cover under the endoscope3. 拆卸内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Remove the ceiling assembly4. 拆卸顶棚总成 Reference: Ceiling assembly参考：顶棚总成   Note:提示： ♦  Just open the front side of the ceiling and disconnect the connector.只需扒开顶棚前侧断开接插件即可。

5. Disassemble the GPS antenna assembly5. 拆卸GPS天线总成

1 Disconnect connector A and pry out the GPS antenna assembly.断开接插件A，撬出GPS天线总成。 Recommended tools: clip remover推荐工具：卡扣起子

Installation procedure安装程序

1. Install GPS antenna assembly1. 安装GPS天线总成

1 Place and adjust the GPS antenna assembly to the installation position, press and fasten it firmly, and connect connector A.放置并调整GPS天线总成到安装位置，用力按压并扣紧，连接接插件A。

2. Install the ceiling assembly2. 安装顶棚总成 Reference: Ceiling assembly参考：顶棚总成

3. Install the decorative cover under the endoscope3. 安装内视镜下装饰盖 Reference: Decorative cover under endoscope参考：内视镜下装饰盖

4. Install decorative cover on endoscope4. 安装内视镜上装饰盖 Reference: Interior mirror upper decorative cover参考：内视镜上装饰盖

5. Connect the negative terminal of the 12V battery, start the vehicle, and check that the GPS antenna assembly should work normally.5. 连接蓄电池负极，启动车辆，检查GPS天线总成应正常工作