In-car detection antenna (rear floor)车内探测天线(后地板)
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the second row seat cushion assembly2. 拆卸第二排座椅坐垫总成
|
|
3. Remove the detection antenna in the car3. 拆卸车内探测天线
|
 |
1 Disconnect connector A, remove the 2 fixing bolts ①, and remove the vehicle detection antenna B.断开接插件A，拆卸2颗固定螺栓①，取下车内探测天线B。
|
Installation procedure安装程序
|
1. Install the in-car detection antenna1. 安装车内探测天线
|
|
|
1 Place and adjust the in-vehicle detection antenna B to the installation position, install and tighten 2 fixing bolts ①, and connect connector A.放置并调整车内探测天线B到安装位置，安装2颗固定螺栓①并紧固，连接接插件A。
|
|
2. Install the second row seat cushion assembly2. 安装第二排座椅坐垫总成
|
|
3. Connect the negative terminal of the 12V battery, start the vehicle, and check that the keyless entry system should work normally.3. 连接蓄电池负极，启动车辆，检查无钥匙进入系统应正常工作
|