USB charger (in front of the secondary instrument panel)USB充电器(副仪表前)
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the switch panel assembly2. 拆卸开关面板总成
|
|
3. Remove the USB charger3. 拆卸USB充电器
|
 |
1 Pry out the USB charger A.撬出USB充电器A。
|
Installation procedure安装程序
|
1. Install USB charger1. 安装USB充电器
|
|
|
1 Place and adjust USB charger A to a fixed position and fasten it.放置并调整USB充电器A到固定位置并扣紧。
|
|
2. Install the switch panel assembly2. 安装开关面板总成
|
|
3. Connect the negative terminal of the 12V battery, start the vehicle, and check that the USB charger should work normally.3. 连接蓄电池负极，启动车辆，检查USB充电器应正常工作
|