Sub-instrument panel rear panel assembly副仪表板后面板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the rear upper panel assembly2. 拆卸后上面板总成 Reference: Rear upper panel assembly参考：后上面板总成

3. Remove the rear panel assembly of the sub-instrument panel3. 拆卸副仪表板后面板总成

1 Pry out the rear panel assembly of the sub-instrument panel.撬出副仪表板后面板总成。 Recommended tools: Interior parts removal tools推荐工具：内饰件拆卸工具   Note:提示： ♦  Pay attention to the position of the claw at point 10 in the picture.注意图示10处卡爪位置。 2 Disconnect the connector and remove the rear panel assembly of the sub-instrument.断开接插件，取下副仪表后面板总成。

3 Remove the 2 fixing screws ① and remove the USB charger.拆卸2颗固定螺钉①，取下USB充电器。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀

Installation procedure安装程序

1. Install the sub-instrument panel rear panel assembly1. 安装副仪表板后面板总成

1 Place and adjust the USB charger to the installation position, install 2 fixing screws ① and tighten.放置并调整USB充电器到安装位置，安装2颗固定螺钉①并紧固。 Recommended tools: Phillips screwdriver推荐工具：十字螺丝刀 2 Connect the connector to the USB charger.连接接插件到USB充电器。

1 Place and adjust the rear panel assembly of the sub-instrument panel to the installation position, align the 10 clip positions and press firmly to ensure that it is installed in place.放置并调整副仪表板后面板总成到安装位置，对准10处卡子位置用力按压，确保安装到位。

2. Install the rear upper panel assembly2. 安装后上面板总成 Reference: Rear upper panel assembly参考：后上面板总成

3. Connect the negative terminal of the 12V battery3. 连接蓄电池负极