Integrated body control module集成式车身控制模块
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the driver's side lower left decorative panel assembly2. 拆卸驾驶侧左下装饰板总成
|
|
3. Remove the driver’s side lower cover panel assembly3. 拆卸驾驶侧下护板总成
|
|
4. Remove the integrated body control module4. 拆卸集成式车身控制模块
|
 |
1 Disconnect connectors A, B, C, and D.断开接插件A、B、C、D。
|
 |
2 Remove 2 fixing bolts ① and 1 fixing nut ②, and remove the integrated body control module with mounting bracket.拆卸2颗固定螺栓①、1颗固定螺母②，取下集成式车身控制模块带安装支架。
|
 |
3 Separate body control module mounting bracket A and integrated body control module B.分离车身控制模块安装支架A、集成式车身控制模块B。
|
Installation procedure安装程序
|
1. Install the integrated body control module1. 安装集成式车身控制模块
|
|
|
1 Assemble integrated body control module B to body control module mounting bracket A.组合集成式车身控制模块B到车身控制模块安装支架A。
|
|
|
2 Place and adjust the integrated body control module with bracket to the installation position, install 2 fixing bolts ① and 1 fixing nut ② and tighten them.放置并调整集成式车身控制模块带支架到安装位置，安装2颗固定螺栓①、1颗固定螺母②并紧固。
|
|
|
3 Connect connectors A, B, C, and D to the integrated body control module.连接接插件A、B、C、D到集成式车身控制模块。
|
|
2. Install the driver's side lower cover panel assembly2. 安装驾驶侧下护板总成
|
|
3. Install the driver's side lower left decorative panel assembly3. 安装驾驶侧左下装饰板总成
|
|
4. Connect the negative terminal of the 12V battery, start the vehicle, and check that all electrical components of the vehicle are working properly.4. 连接蓄电池负极，启动车辆，检查车辆各电气部件应正常工作
|