Brake pedal assembly制动踏板总成

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the brake light switch2. 拆卸制动灯开关 Reference: Stop light switch参考：制动灯开关

3. Remove the brake pedal assembly3. 拆卸制动踏板总成

1 Press push rod clip A to disconnect the push rod of the integrated brake control system from the brake pedal assembly.按压推杆卡扣A，断开集成式制动控制系统推杆与制动踏板总成的连接。

2 Remove the 6 fixing nuts ① and take out the brake pedal assembly A.拆卸6颗固定螺母①，取出制动踏板总成A。 Recommended tools: 13mm socket推荐工具：13mm套筒

Installation procedure安装程序

1. Install brake pedal assembly1. 安装制动踏板总成

1 Place and adjust brake pedal assembly A to the installation position, install 6 fixing nuts ① and tighten them.放置并调整制动踏板总成A到安装位置，安装6颗固定螺母①并紧固。 Recommended tools: 13mm socket推荐工具：13mm套筒 Torque requirement: 20-24N·m扭矩要求：20-24N•m

2 Place and adjust the integrated brake control system push rod to the brake pedal clip installation position, and install push rod clip A in place.放置并调整集成式制动控制系统推杆到制动踏板卡扣安装位置，将推杆卡扣A安装到位。   Caution:注意： ♦  Pull back the brake pedal and check that the push rod clip should be installed in place and the brake pedal should be at the highest position, otherwise it should be reinstalled.回拉制动踏板，检查推杆卡扣应安装到位、制动踏板应处于最高位置，否则应重新安装。

2. Install the brake light switch2. 安装制动灯开关 Reference: Stop light switch参考：制动灯开关

3. Connect the negative terminal of the 12V battery, start the vehicle, and conduct a road test3. 连接蓄电池负极，起动车辆，路试检查