Brake light switch

Brake light switch制动灯开关

Removal procedure拆卸程序

1. Preparation1. 准备工作

1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。

2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the brake light switch2. 拆卸制动灯开关

1 Disconnect connector A, unscrew counterclockwise and remove brake light switch B.断开接插件A，逆时针拧下并取出制动灯开关B。

NOTE：

♦

The brake light switch can be removed by turning it approximately 45° counterclockwise.逆时针旋转约45°即可拆下制动灯开关。

Installation procedure安装程序

1. Install the brake light switch1. 安装制动灯开关

1 Place and adjust brake light switch B to the installation position, rotate it clockwise to install it in place, and connect connector A.放置并调整制动灯开关B到安装位置，顺时针旋转使其安装到位，连接接插件A。

NOTE：

♦

Rotate it clockwise about 45° to install the brake light switch in place.顺时针旋转约45°即将制动灯开关安装到位。

CAUTION：

♦

The contacts should be fully pressed in before tightening to avoid malfunction of the brake light switch.紧固前应将触点完全压入，避免制动灯开关工作失效。

♦

Do not insert the brake light switch too far to avoid long-term stress on it and damage to the components.切勿将制动灯开关插入过多，避免其长期受力而导致部件损坏。

2. Connect the negative terminal of the 12V battery, start the vehicle, and check that the brake lights should work normally.2. 连接蓄电池负极，启动车辆，检查制动灯应正常工作