ITS to charger water pipe Ⅰ (to autonomous driving)ITS至充电机水管Ⅰ(至自动驾驶)
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
3 Lift the vehicle.举升车辆。
|
|
2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成
|
|
3. Drain the coolant from the temperature control system3. 排放温控系统冷却液
|
|
4. Remove ITS to charger water pipe Ⅰ4. 拆卸ITS至充电机水管Ⅰ
1 Disconnect the pipe retaining clip.断开管路固定卡。
|
 |
2 Disconnect water pipe joints A and B, and remove the fixing bolts ①.断开水管接头A、B，拆卸固定螺栓①。
|
 |
3 Disconnect the water pipe connectors A and B, and take out the ITS to the charger water pipe I.断开水管接头A、B，取出ITS至充电机水管Ⅰ。
|
Installation procedure安装程序
|
1. Install ITS to charger water pipe Ⅰ1. 安装ITS至充电机水管Ⅰ
|
|
|
1 Place and adjust the ITS to the charger water pipe I to the installation position, and install water pipe joints A and B.放置并调整ITS至充电机水管Ⅰ到安装位置，安装水管接头A、B。
|
|
|
2 Connect the water pipe joints A and B, install the fixing bolts ① and tighten them.连接水管接头A、B，安装固定螺栓①并紧固。
3 Install the pipe fixing card.安装管路固定卡。
|
|
2. Fill the temperature control system coolant2. 加注温控系统冷却液
|
|
3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成
|
|
4. Connect the negative terminal of the 12V battery, land the vehicle, start the vehicle and drive away from the lift, check that the cooling system should be working normally4. 连接蓄电池负极，降落车辆，起动车辆并驶离举升机，检查冷却系统应正常工作
|