ITS to IDU water pipe ⅡITS至IDU水管Ⅱ
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
3 Lift the vehicle.举升车辆。
|
|
2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成
|
|
3. Drain the coolant from the temperature control system3. 排放温控系统冷却液
|
|
4. Remove ITS to IDU water pipe II4. 拆卸ITS至IDU水管Ⅱ
|
 |
1 Disconnect connector A from ITS to IDU water pipe II and from ITS to charger water pipe I.断开ITS至IDU水管Ⅱ接头A与ITS至充电机水管Ⅰ的连接。
|
 |
2 Disconnect joint A of the ITS to IDU water pipe II from the integrated electric drive assembly, disengage the fixing card, and remove the ITS to IDU water pipe II. .断开ITS至IDU水管Ⅱ接头A与集成电力驱动总成的连接，脱开固定卡，取下ITS至IDU水管Ⅱ。。
|
Installation procedure安装程序
|
1. Install ITS to IDU water pipe II1. 安装ITS至IDU水管Ⅱ
|
|
|
1 Place and adjust the ITS to the IDU water pipe II to the installation position, and connect the water pipe joint A to the integrated electric drive assembly.放置并调整ITS至IDU水管Ⅱ到安装位置，连接水管接头A到集成电力驱动总成。
|
|
|
2 Connect ITS to IDU water pipe II connector A to ITS to charger water pipe I, and install the fixing card.连接ITS至IDU水管Ⅱ接头A到ITS至充电机水管Ⅰ，安装固定卡。
|
|
2. Fill the temperature control system coolant2. 加注温控系统冷却液
|
|
3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成
|
|
4. Land the vehicle, connect the negative terminal of the 12V battery, start the vehicle and drive away from the lift, check that the cooling system should be working normally4. 降落车辆，连接蓄电池负极，起动车辆并驶离举升机，检查冷却系统应正常工作
|