Engine hood lock assembly发动机罩锁总成
Removal procedure拆卸程序
|
1. Preparation1. 准备工作
1 Park the vehicle on a flat road, activate the parking brake, and put the vehicle's power supply in the "OFF" state.将车辆停在平坦路面，启用驻车制动，使整车电源处于“OFF”状态。
2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。
|
|
2. Remove the front compartment front upper cover panel assembly2. 拆卸机舱前上护板总成
|
|
3. Remove the hood lock assembly3. 拆卸发动机罩锁总成
|
 |
1 Disconnect connector A, remove the 2 fixing bolts ①, disconnect the hood lock cable B from the hood lock assembly, and remove the hood lock assembly.断开接插件A，拆卸2颗固定螺栓①，断开发动机罩锁拉索B与发动机罩锁总成的连接，取下发动机罩锁总成。
|
Installation procedure安装程序
|
1. Install the hood lock assembly1. 安装发动机罩锁总成
|
|
|
1 Connect the hood lock cable B to the hood lock assembly, place and adjust the hood lock assembly to the installation position, install and tighten 2 fixing bolts ①, and connect connector A.连接发动机罩锁拉索B到发动机罩锁总成，放置并调整发动机罩锁总成到安装位置，安装2颗固定螺栓①并紧固，连接接插件A。
|
|
2. Install the front compartment front upper cover panel assembly2. 安装机舱前上护板总成
|
|
3. Connect the negative terminal of the 12V battery, start the vehicle, and check that the hood lock assembly should work normally.3. 连接蓄电池负极，启动车辆，检查发动机罩锁总成应正常工作
|