Left rear door stopper assembly左后门限位器总成

Note:提示： ♦  The disassembly and assembly procedures for the left and right rear door stopper assemblies are basically the same. The following content takes the left side as an example.左、右后门限位器总成的拆装程序基本相同，下述内容以左侧为例进行操作。

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Park the vehicle on a flat road, activate the parking brake, and turn the vehicle power supply to "OFF".将车辆停在平坦路面，启用驻车制动，整车电源处于“OFF”状态。 2 Disconnect the negative terminal of the 12V battery.断开蓄电池负极。

2. Remove the left rear door switch panel assembly2. 拆卸左后门开关面板总成 Reference: Left rear door switch panel assembly参考：左后门开关面板总成

3. Remove the left rear door trim panel assembly3. 拆卸左后门饰板总成 Reference: Left rear door trim panel assembly参考：左后门饰板总成

4. Remove the left rear door woofer4. 拆卸左后门低音扬声器 Reference: Subwoofer assembly (left rear door)参考：低音扬声器总成(左后门)

5. Remove the left rear door stopper assembly5. 拆卸左后门限位器总成

1 Remove the fixing bolts ① and 2 fixing nuts ②, and take out the left rear door stopper assembly from inside the door welding assembly.拆卸固定螺栓①、2颗固定螺母②，从车门焊合总成内部取出左后门限位器总成。 Recommended tools: 10mm socket推荐工具：10mm套筒

Installation procedure安装程序

1. Install the left rear door stopper assembly1. 安装左后门限位器总成

1 Place and adjust the left rear door stopper assembly to the installation position, install 2 fixing nuts ② and 1 fixing bolt ① and tighten them.放置并调整左后门限位器总成到安装位置，安装2颗固定螺母②、1颗固定螺栓①并紧固。 Recommended tools: 10mm socket推荐工具：10mm套筒 Torque requirements: 9-11N·m①, 16-20N·m②扭矩要求：9-11N•m①、16-20N•m②

2. Install the left rear door subwoofer2. 安装左后门低音扬声器 Reference: Subwoofer assembly (left rear door)参考：低音扬声器总成(左后门)

3. Install the left rear door trim panel assembly3. 安装左后门饰板总成 Reference: Left rear door trim panel assembly参考：左后门饰板总成

4. Install the left rear door switch panel assembly4. 安装左后门开关面板总成 Reference: Left rear door switch panel assembly参考：左后门开关面板总成

5. Connect the negative terminal of the 12V battery and check that the rear door opens and closes and the limit position should be normal.5. 连接蓄电池负极，检查后车门开合、限位应正常