Differential gear oil差减齿轮油

Discharge differential gear oil排放差减齿轮油

1. Lift the vehicle and place an oil recovery container under the vehicle1. 举升车辆，在车辆下方放置油液回收容器

2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

3. Remove the oil drain plug of the reducer and drain the differential gear oil.3. 拆卸减速器放油螺塞，排放差减齿轮油 Recommended tools: H10 socket推荐工具：H10套筒

4. Remove the reducer oil plug4. 拆卸减速器加油螺塞 Recommended tools: H10 socket推荐工具：H10套筒

5. After the oil is drained, install and tighten the oil drain plug.5. 待油液排放完毕，安装并紧固放油螺塞 Recommended tools: H10 socket推荐工具：H10套筒 Torque requirement: 30-39N·m扭矩要求：30-39N•m

Fill differential reduction gear oil加注差减齿轮油

1. Use a gear oil filling machine to add differential gear oil so that the gear oil level is flush with the lower edge of the filling port.1. 使用齿轮油加注机加注差减齿轮油，使齿轮油液面与加注口下边缘平齐 Special Tool: Gear Oil Filling Device专用工具：齿轮油加注装置 Gear oil model: Mobil 304齿轮油型号：美孚304 Gear oil filling amount: 1.7~1.9L (applicable to independent Ruipa XOF motor)齿轮油加注量：1.7~1.9L(适用自主锐湃XOF电机) Gear oil model: Mobil 304齿轮油型号：美孚304 Gear oil filling amount: 0.55~0.65L (applicable to Nidec motors)齿轮油加注量：0.55~0.65L(适用于日电产电机) Gear oil model: Castrol 805C齿轮油型号：嘉实多 805C Gear oil filling amount: 0.55~0.65L (applicable to Inovance Motor)齿轮油加注量：0.55~0.65L(适用于汇川电机)

2. Install and tighten the reducer oil plug ①2. 安装并紧固减速器加油螺塞① Recommended tools: H10 socket推荐工具：H10套筒 Torque requirement: 30-39N·m扭矩要求：30-39N•m

3. Wipe the remaining oil on the oil filling plug and oil drain plug. After a few minutes, check that there is no oil leakage at each plug.3. 擦拭加油螺塞、放油螺塞处残留油液，若干分钟后检查各螺塞处应无油液泄漏

4. Install the front compartment front lower cover panel assembly4. 安装机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

5. Land the vehicle, start the vehicle and drive away from the lift5. 降落车辆，起动车辆并驶离举升机