Removal procedure拆卸程序
|
|
1. Preparation1. 准备工作
1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。
2 Lift the vehicle.举升车辆。
|
|
|
2. Drain brake fluid2. 排放制动液
|
|
|
3. Remove the front compartment front lower cover panel assembly3. 拆卸机舱前下护板总成
|
|
|
4. Remove the right rear brake pipe Ⅰ4. 拆卸右后制动硬管Ⅰ
|
|
|
1 Remove the oil pipe joint nut ① and disconnect the right rear brake hard pipe Ⅰ from the integrated brake control system.拆卸油管接头螺母①，断开右后制动硬管Ⅰ与集成式制动控制系统的连接。
|
|
Recommended tools: 10mm tubing wrench推荐工具：10mm油管扳手 |
|
|
|
2 Remove the oil pipe joint nut ①, disconnect the right rear brake hard pipe Ⅰ from the brake hard pipe connector, and remove the right rear brake hard pipe Ⅰ.拆卸油管接头螺母①，断开右后制动硬管Ⅰ与制动硬管连接器的连接，取下右后制动硬管Ⅰ。
|
|
Recommended tools: 10mm tubing wrench推荐工具：10mm油管扳手 |
|
Installation procedure安装程序
|
|
1. Install the right rear brake pipe Ⅰ1. 安装右后制动硬管Ⅰ
|
|
|
1 Place and adjust the right rear brake hard pipe Ⅰ to the installation position, install the right rear brake hard pipe Ⅰ to the brake hard pipe connector, install the oil pipe joint nut ① and tighten it.放置并调整右后制动硬管Ⅰ到安装位置，安装右后制动硬管Ⅰ到制动硬管连接器，安装油管接头螺母①并紧固。
|
|
Recommended tools: 10mm tubing wrench推荐工具：10mm油管扳手 |
|
|
Torque requirement: 15-19N·m扭矩要求：15-19N•m |
|
|
|
2 Install the right rear brake hard pipe Ⅰ to the integrated brake control system, install the oil pipe joint nut ① and tighten it.安装右后制动硬管Ⅰ到集成式制动控制系统，安装油管接头螺母①并紧固。
|
|
Recommended tools: 10mm tubing wrench推荐工具：10mm油管扳手 |
|
|
Torque requirement: 15-19N·m扭矩要求：15-19N•m |
|
|
|
2. Add brake fluid and bleed air2. 加注制动液并排气
|
|
|
3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成
|
|
|
4. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check4. 降落车辆，起动车辆并驶离举升机，路试检查
|
Right rear brake pipeⅠ右后制动硬管Ⅰ
