Brake hose connector制动硬管连接器

Removal procedure拆卸程序

1. Preparation1. 准备工作 1 Drive the vehicle into the lift position, activate the parking brake, and put the vehicle power supply in the "OFF" state.将车辆驶入举升机举升位置，启用驻车制动，整车电源处于“OFF”状态。 2 Lift the vehicle.举升车辆。

2. Remove the front compartment front lower cover panel assembly2. 拆卸机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

3. Drain brake fluid3. 排放制动液 Reference: brake fluid参考：制动液

4. Remove the brake pipe connector4. 拆卸制动硬管连接器

1 Remove the 4 oil pipe joint nuts ①, disconnect the brake hard pipe from the brake hard pipe connector A, remove the fixing nut ②, and remove the brake hard pipe connector A.拆卸4颗油管接头螺母①，断开制动硬管与制动硬管连接器A的连接，拆卸固定螺母②，取下制动硬管连接器A。 Recommended tools: 10mm tubing wrench ①, 10mm socket ②推荐工具：10mm油管扳手①、10mm套筒②

Installation procedure安装程序

1. Install the brake pipe connector1. 安装制动硬管连接器

1 Place and adjust the brake hard pipe connector A to the installation position, install the fixing nut ② and tighten it, connect the brake hard pipe to the brake hard pipe connector A, install 4 oil pipe joint nuts ① and tighten it.放置并调整制动硬管连接器A到安装位置，安装固定螺母②并紧固，连接制动硬管到制动硬管连接器A，安装4颗油管接头螺母①并紧固。 Recommended tools: 10mm tubing wrench ①, 10mm socket ②推荐工具：10mm油管扳手①、10mm套筒② Torque requirements: 15-19N·m①, 6-10N·m②扭矩要求：15-19N•m①、6-10N•m②

2. Add brake fluid and bleed air2. 加注制动液并排气 Reference: brake fluid参考：制动液

3. Install the front compartment front lower cover panel assembly3. 安装机舱前下护板总成 Reference: Front compartment front lower cover panel assembly参考：机舱前下护板总成

4. Land the vehicle, start the vehicle and drive off the lift, conduct road test and check4. 降落车辆，起动车辆并驶离举升机，路试检查